this was the first time we actually ran it. unfortunatly, we didnt have complete control over the I Beam structure, or else it would have been much burlier. we figured wed have alot of deflection, and yup, we sure did, and that pic is only around 30 PSI. we are planning on adding center reinforcements, however they have to allow the press to be opened and accessed. the 1 idea i had was building a structure on the outside of the top and bottom beam that extended out beyond the sides of the mold. wrapped around that would be a HEAVY duty chain(s) tightened with a chain winch. Good idea? any others?
(PS, that setup there is kinda jurry rigged lol. there wont be any voids between the beam and molds under full pressure)
oh yea, you guys like the tip spacer adjustment? it works like a charm, and locks in any size ski, from 130-230!
