Ski Builders Forum

Posted: **Fri Mar 28, 2008 4:39 pm**

I am curious whether the fiberglass has to be one long piece that spreads the length of the board, or can it be two pieces end to end?

If it were fine to lay them end to end, I could save a lot of money on fiberglass.

Esscher

Posted: **Fri Mar 28, 2008 7:01 pm**

Hi esscher.

I dont think It would affect the performance to much. I would definitely overlap the pieces by 2 or 3 cms or more though.

Posted: **Sat Mar 29, 2008 9:43 am**

I have two short pieces of glass on more than one ski. Normally overlapped it where the binding area was to strengthen that area.

Ski Builders Forum

Does the fiberglass have to be one long piece?

Does the fiberglass have to be one long piece?