Poor Boyz Revolver Ski Layup

[falls]

http://www.youtube.com/watch?v=Pd2HcAya ... ata_player
Official link. Prob better resolution.
Line skis are claiming it (but line is K2 anyway).

Watching this the other day it looks like the edge material actually passes through a sandblaster before it gets to the bender. Pretty rad!

[n.marshall]

For gluing edges onto base material, I have had really good luck with 2P-10. It comes in 4 different viscosities, I usually use the Thick or Medium. I have found that it works better than superglue, but I cant figure out what goes into 2P-10 and it could be another cyanoacrylate glue. If you have two pieces that you need to glue quickly, the activator works really good also.

[vinman]

According to the MSDS 2P-10 is a cyanoacrylate adhesive with works with or without an activator.

Has anyone used the gorilla glue cyano glue? It says it has some rubber in the mix to make it less brittle. Not sure this is really an issue for us as the super glue doesn't really have much to do with the final adhesion of the edge.

[falls]

When they glued the edges on they put a continuous line of glue around the base material and edge teeth. I wondered if this helped prevent epoxy from being squeezed in between the edge and base?

[Richuk]

Insomnia used gorilla.