just great!
water alone is not sufficient. you need hot, boiling water or steam to bend the skis....the cold water won`t penetrate the wood as deep as steam does...
Tu n'as pas bien lu le livre du TCF: il faut du vapeur pour plier les skis, la moule était place’ dans un boite connecte a une marmite.
Tu peux essayer des plonger le pointes dans l'eau bouillent pendant quelques minutes.
C'etait du sapin? Il faudrait essayer avec du frene.
Bon chance.
salut.
j'ai plongé les spatules 1h dans l'eau frissonnante (environs 80°C), sachant que le bois été du "douglas" mais le probléme c qu'il y avait des noeud au niveaux des spatule et c ca qui a casser...j'aurais du le savoir..
The key is to steam the skis without letting them get too wet(keep the condensation from dripping onto the wood(they warp as they dry if they get too wet). You must steam them for about 1hour then put them in the camber jig that you show, slowly bending the tip and tail bends( I built a two piece jig so I can bend the tails easier. Allow to slowly air dry in a room temp./normal humidity place for 18-24hr.