this message is from Breid19 -- i moved it:
Hi Kam,
Great looking skis. I just finished my first pair (will post some pics if I can figure out how) with the following lay up
clear p-tex top
fabric
24 oz triaxial glass
maple core
24 oz triaxial glass
vdf rubber over edges
ptex base
These skis came out quite soft but still skied quite well on the soft stuff. I did notice some plowing (excessive ski flex) in crud.
Kam, how did you get all the air bubbles out from below the top sheet?
Does anyone know where to get titanal in north america? Is this typically used in race/hard pack skis or is it also used in powder skis?
I'm now looking to stiffen the next pair but am unsure if I should use more glass, increase the profile thickness or use some strips of carbon. Any suggestions?
thanks
bill
Kaweah: rubber, aluminum, steel, glass, and wood
Moderators: Head Monkey, kelvin, bigKam, skidesmond, chrismp
-
- Posts: 22
- Joined: Mon Mar 12, 2007 3:42 am
- Location: ports., nh
- Contact:
Having seen these skis in action I can attest to both their softness and dampness.
We (Kams friends, Weezer and I) would wait at the top of a pitch while Kam skied down and setup video. The whole time people would be making comments like “look at those things flex” and “they look almost liquid”. We all finally agreed that the Kaweahs “slither”. It wasn’t uncommon to see them with two or three inflection points simultaneously as they absorbed the hard under layer at Snowbird.
We (Kams friends, Weezer and I) would wait at the top of a pitch while Kam skied down and setup video. The whole time people would be making comments like “look at those things flex” and “they look almost liquid”. We all finally agreed that the Kaweahs “slither”. It wasn’t uncommon to see them with two or three inflection points simultaneously as they absorbed the hard under layer at Snowbird.
- Ben