About my board building efforts: I built ~10 boards(over ~18 years), all except the first two with vacuum infusion. Most of my boards are alpine carving boards, typically carbon or carbon/titanal layups. The boards in the pictures below is a board for my daughter, 145 x24 cm, triax glass laminate, sublimated PA12 topsheet. The resin us Epikote RIMR135 / RIMH137
My mould consists of a 1.5mm stainless steel plate which I bend to the camber/rocker profile I want. The middle 140 cm is glued to a 22mm MDF plate to ensure a smooth curve (140 cm is my minimum running length
![Smile :)](./images/smilies/icon_smile.gif)
Mould with plywood ramp and tacky tape: Base with edges: I use 30gsm glass fleece for better resin flow and for flow between impermeable layers. Here I use it to get resin between the edge and the VDS foil. (Glass fabrics have good flow, for carbon I often add glass fleece to improve flow).
Base with fleece and VDS: Triax glass 750 gsm: This core I attached the tip and tail spacers, normally I have them separate. I drilled small 2mm holes to allow resin to flow between top and bottom: More to follow