Obygden Teknologi - s02

Document your personal work here. Show photos, movies, and share your secrets.

Moderators: Head Monkey, kelvin, bigKam, skidesmond, chrismp

o.ahlgren
Posts: 38
Joined: Thu Feb 06, 2020 10:48 pm

Re: Obygden Teknologi - s02

Post by o.ahlgren »

Ah ok got it.

I’m not using a heat blanket, just putting a box on top of the vacuum press and a heater inside.

Thanks for the ideas, appreciated!
o.ahlgren
Posts: 38
Joined: Thu Feb 06, 2020 10:48 pm

Re: Obygden Teknologi - s02

Post by o.ahlgren »

so i got to pressing the board this weekend.
wen't well until one (out of two) dowels (for guiding/keeping core in place) came off the base.

i had some reference points so i could put it in place by measuring, but got a bit hairy.
since i was worried it had shifted (and it's a splitboard) i immediately made the split after i had made the rough cut out of the shape, to verify if the core had shifted or not, but luckily i hadn't.

what did happen however as i was fiddling with getting the core in place was that the tip fillers moved slightly and got on top of the core.
i guess this won't be anything but a cosmetic issue.
press3.JPG
press3.JPG (913.2 KiB) Viewed 1311 times
press2.JPG
press2.JPG (913.2 KiB) Viewed 1311 times
press1.JPG
press1.JPG (804.44 KiB) Viewed 1311 times
Post Reply