can i fix messed up core?
Posted: Mon Dec 14, 2020 5:20 am
hi guys,
managed to screw up one of my cores that i'm working on while I was profiling them.
don't ask me exactly how this happened, but i'm using a router bridge and my mind went somewhere else for a little bit.
it's a splitboard core, and as you can see i went straight through it where the center sidewall is.
it's a pauwlownia/poplar mix core with ABS sidewalls. 2.5 - 7.7 - 2.5mm.
see the attached image. any ideas of how i could go about fixing it? or does it go straight to the bin?
managed to screw up one of my cores that i'm working on while I was profiling them.
don't ask me exactly how this happened, but i'm using a router bridge and my mind went somewhere else for a little bit.
it's a splitboard core, and as you can see i went straight through it where the center sidewall is.
it's a pauwlownia/poplar mix core with ABS sidewalls. 2.5 - 7.7 - 2.5mm.
see the attached image. any ideas of how i could go about fixing it? or does it go straight to the bin?