Edges - CDW vs Metalldeutsch (SWD - Friedrich Deutsch)
Posted: Tue Nov 24, 2015 5:05 am
Hi,
Does anyone have a comparison between those tho edge manufacturers? I have been using Metalldeutsch and it was ok, but I have the feeling that edges were rusting easily - on a ready made ski (not during the storage on shelf).
I use standard CK60 edge, because for that the MOQ is low. I know that they use 100Cr6 material as well - does anyone know if it's better?
And regarding the other manufacturer - does anyone have a comparison if CDW edges are better/worse (more rust resistant). They claim to use CK67 material but as they said - after many tests this material is not any (considerably) better than CK60 (60% of carbon).
I would prefer to use CDW because they have smaller MOQ for bend edges:) But first of all I want to use better - more rustproof resistant edges. I know - rusting is not the only factor, but it's important for customers.
Anyone? Thanks in advance,
PS: I am located in Europe
Does anyone have a comparison between those tho edge manufacturers? I have been using Metalldeutsch and it was ok, but I have the feeling that edges were rusting easily - on a ready made ski (not during the storage on shelf).
I use standard CK60 edge, because for that the MOQ is low. I know that they use 100Cr6 material as well - does anyone know if it's better?
And regarding the other manufacturer - does anyone have a comparison if CDW edges are better/worse (more rust resistant). They claim to use CK67 material but as they said - after many tests this material is not any (considerably) better than CK60 (60% of carbon).
I would prefer to use CDW because they have smaller MOQ for bend edges:) But first of all I want to use better - more rustproof resistant edges. I know - rusting is not the only factor, but it's important for customers.
Anyone? Thanks in advance,
PS: I am located in Europe