Hi, As is the typical story I guess... I've been lurking around the forum for a few months and signed up recently so this is my first post.
To date I have not built any snowboards or snow ski's but I have built a few wakeboards (which is my main focus) there is a lot of crossover between our build materials and techniques so I was drawn to this forum.
My current setup is a vacuum bagged cassette with a hybrid press former i.e. no external pressure from a hose or alike but the cassette is pressed to form the rocker/camber etc... built into an oven. The oven is nearly finished now I should have the first board off the mould in a couple of weeks.
I'm wanting up up my game on the boards now with graphics in the top and base, integrated base materials for sliders/rails/ramps etc...
There's loads of info for me to trawl through on this place still so if I'm a little quiet and don't post much it's probably as I'm still reading!
Once I've got past my 2 posts I'll throw up some pictures.
Chris (in the UK)
Hello, just joined
Moderators: Head Monkey, kelvin, bigKam, skidesmond, chrismp
-
- Posts: 70
- Joined: Tue Feb 17, 2015 2:37 am
- Location: England/France
- Contact:
-
- Posts: 70
- Joined: Tue Feb 17, 2015 2:37 am
- Location: England/France
- Contact:
-
- Posts: 70
- Joined: Tue Feb 17, 2015 2:37 am
- Location: England/France
- Contact:
Unless it's upside down
In case anyone is interested, it's 2.84kg (6.2lb) without bindings, 56" long, 16.5" wide and 1/4" core, full carbon (bi-ax, twill & plain woven) with carbon stringers & wrapped edges (is that capped construction in these circles?), the flex profile varies along the length so the tips have loads of flex and quick rebound with the middle section much stiffer with a progressive transition between.
This one is designed for the cable park i.e. sliders, kickers & ramps.
![Wink ;)](./images/smilies/icon_wink.gif)
In case anyone is interested, it's 2.84kg (6.2lb) without bindings, 56" long, 16.5" wide and 1/4" core, full carbon (bi-ax, twill & plain woven) with carbon stringers & wrapped edges (is that capped construction in these circles?), the flex profile varies along the length so the tips have loads of flex and quick rebound with the middle section much stiffer with a progressive transition between.
This one is designed for the cable park i.e. sliders, kickers & ramps.
Re: Hello, just joined
The cassette/press/oven i would like to see, sounds interestingchrislandy wrote:My current setup is a vacuum bagged cassette with a hybrid press former i.e. no external pressure from a hose or alike but the cassette is pressed to form the rocker/camber etc... built into an oven. The oven is nearly finished now I should have the first board off the mould in a couple of weeks.
Tom