compensating for camber/tip/tail relaxing
Posted: Mon Jan 19, 2015 7:13 am
Hello everyone
I was just wondering in your experience how much to over compensate for relaxation of camber/tip and tail heights post un-moulding and de-flashing?
I am aiming for a 70mm tip, 15mm camber and a 45mm tail.
I'll use a vacuum press, heated underneath and on top (electric blanket!). I leave the pump running for 10 hrs, leave the heat on for a further 14 and then cool in the mould for a further 12 hrs.
Anyone have a view?
Thanks
Gilo
I was just wondering in your experience how much to over compensate for relaxation of camber/tip and tail heights post un-moulding and de-flashing?
I am aiming for a 70mm tip, 15mm camber and a 45mm tail.
I'll use a vacuum press, heated underneath and on top (electric blanket!). I leave the pump running for 10 hrs, leave the heat on for a further 14 and then cool in the mould for a further 12 hrs.
Anyone have a view?
Thanks
Gilo