Universal mounting jig
Posted: Tue Jun 04, 2013 11:40 am
I do inserts in everything now... even if I don't think I'll swap the bindings... making the CNC locate the inserts means I can't screw up the mounting
Ski Builders Forum
Site dedicated to DYI ski building
http://www.skibuilders.com/phpBB2/
Universal mounting jig
Page 1 of 1
Posted: Tue Jun 04, 2013 1:39 pm
I tried to make something similar a few years ago, and it was an abysmal failure. This thing looks sweet! Don't see anything about cost.
I do inserts in everything now... even if I don't think I'll swap the bindings... making the CNC locate the inserts means I can't screw up the mounting
I do inserts in everything now... even if I don't think I'll swap the bindings... making the CNC locate the inserts means I can't screw up the mounting
Posted: Wed Jun 05, 2013 3:16 am
you're right, I do want one!
$200 inc one set of plates, $25 for each additional set of plates.
there was a mag deal on tgr.
$200 inc one set of plates, $25 for each additional set of plates.
there was a mag deal on tgr.
Posted: Wed Jun 05, 2013 8:08 am
Thanks!
Now I can rest my brain about that!
Now I can rest my brain about that!