edge bender
Posted: Sat Apr 20, 2013 4:16 pm
I watched video from Apex snowboards. At about 4 min they show there edge bender. It different type of what they see around here. Interesting design
Page 1 of 1
Posted: Sat Apr 20, 2013 9:59 pm
Pretty cool! Simple
Posted: Wed Aug 07, 2013 10:47 pm
Sweet vid, but pressing at 180bar wtf!
Posted: Thu Aug 08, 2013 5:22 pm
nobody presses at 180bar... do you mean 18bar?
Posted: Thu Aug 08, 2013 8:26 pm
watch the vidknightsofnii wrote:nobody presses at 180bar... do you mean 18bar?
Posted: Sat Aug 10, 2013 7:59 pm
yea i know what he says in the vid...
but 180 x 14.xx psi?
His press would blow apart at probably 120psi if its pneumatic
Unless their measurement of "180 'bar' " is something than how we measure it.
One bar is close to one atm. 180 atm would kill everyone
but 180 x 14.xx psi?
His press would blow apart at probably 120psi if its pneumatic
Unless their measurement of "180 'bar' " is something than how we measure it.
One bar is close to one atm. 180 atm would kill everyone
Posted: Mon Aug 12, 2013 2:31 am
sarcasm is generally wasted on the yanks I guess
Posted: Thu Aug 15, 2013 5:05 am
sorry, everyone outside NJ has a funny accent, so its hard to read sarcasm