Ski Builders Forum

Need a manual for a Fontaine 680. I have put in new bearings, hoses and pump. But the auto-feed had been removed and they just cut the wires out and I want to wire it back in the right way. I have already called winterstieger and Sun Valley Ski tools with no luck so far. Any help would be appreciated

the svst guys know all about these machines, I talked to the owner once abut this machine.
The autofeed should be wired 110 coming from the switch even though the machine is 220.

I have the same machine. Very easy to wire.

The original feed motor is a baldor dual voltage. You can check what voltage it is wired for by using the wiring diagrams on the plate.

What does your start switch look like?

If I was there I could teach you how to wire it in about 10 minutes.

hit me at - no spaces - rob vanyi @ hotmail . com

thanks for the help. I have it wired in now.