Page 1 of 1
Tip spacer only tip and tail
Posted: Thu Jan 10, 2013 3:12 pm
by ProbsMagobs
Im getting ready to press my first board soon and i feel like it would be easier to cut off the tip and tail of my board and just use tip spacer than have to cut the spacer around my core. my only concern is that it would be too soft and have way too much give. any advice would be great. also, i plan on super gluing inserts to the base as locating pins for my core but i hear that leaves indents on the base and they dont make it all the way to the topsheet. again, any help is appreciated
Posted: Thu Jan 10, 2013 10:46 pm
by deepskis
Dont worry, you can do tipspacers like that. Works fine.
Just dont make the core to thick and thats an easy way to make sure the core stays in position.
Good luck!
Posted: Fri Jan 11, 2013 4:04 am
by ProbsMagobs
Thanks! I had actually seen it done on skis before but never a snowboard so that's why I was curious. My sidewalls aren't quite wide enough for staples so drywall tape will have to do unless somebody else has suggestions
Posted: Fri Jan 11, 2013 7:18 am
by twizzstyle
Medipore tape is another solution that works well.
Posted: Fri Jan 11, 2013 9:50 am
by ProbsMagobs
thanks twizz. I'll be sure to log my progress as soon as I can
Posted: Tue Jan 22, 2013 9:29 pm
by JSquare
We used the inserts as guides. We did it just for one in the front set and one in the back. We did get a bump for each. The solution for us was very quick and dirty... we added extra clearance for these two inserts so that they could freely come up through the core. Board is in the vac mold press right now. I'll let you know how it pans out. Eitherway, my take is that the reason you get bumps is that the inserts need more pressure than you're putting in your process if you let them be an interference fit.
Posted: Mon Mar 25, 2013 7:15 pm
by JSquare
I will update my above post. After bumps in the bases of two boards, we ditched the insert method and went with guide blocks double sticky taped to our vac mold. Flat base no bumps.