Ski Builders Forum

Hi there,
I am not so good at electic devices...

I would like to know if the dp contactor works for my heat blanet.

http://www.auberins.com/index.php?main_ ... 17f5659524

19" x 85" 220v (monophase) 3500w 14.58 amps.
6 Ft. Silicone Leads w/Tab (exit off 19" end)
Type J Thermocouple Wire (surface mounted)

Will it work even tho the contactor works at 40amps and the banket is 15amps?

JoseSnow wrote:Hi there,
I am not so good at electic devices...

I would like to know if the dp contactor works for my heat blanet.

http://www.auberins.com/index.php?main_ ... 17f5659524

19" x 85" 220v (monophase) 3500w 14.58 amps.
6 Ft. Silicone Leads w/Tab (exit off 19" end)
Type J Thermocouple Wire (surface mounted)

Will it work even tho the contactor works at 40amps and the banket is 15amps?

It will work no problem, but make sure what ever you drive it with (temp control) can put out a few amps to engage the contactor.

James

Thank you James,

The contactor will be working with these controler and Relay:

http://www.auberins.com/index.php?main_ ... 17f5659524

http://www.auberins.com/index.php?main_ ... 17f5659524

So should I have no problem??

Thank you for your time
Jose

i have the exact same PID controller and i pair it with

http://www.auberins.com/index.php?main_ ... 17f5659524

and it works very well and is super easy to wire up and use.

But wiill that one resist the 220 volts from the blanket?
Thanks
Jose

here in Chile we work at 220 V. So should I choose the 240v coli voltage contactor?