Ski Builders Forum

I have just been rereading articles about how to keep the base and the core from mooving side to side during pressing. Sounds like the popcicle sticks would work, but earlier I red about using a small tee-nut shaped plastic part that has a thin flange that super glues to the base as a locator. Does anybond know where that article is or know about using these locators.

Are there other good systems, and what is most commonly used. I need something that is school proof. Not fool proof, but school proof. Something careful kids can make work reliabley.

I am still also looking for something to connect the tip and tail spacer securly to the bases so they don't move around.

Thanks in advance

Hadley

Hadley,
I use these. Just figure out what size you want.
Spacers and Standoffs
61 products match your selections
Type Female Unthreaded Round
Female Unthreaded Round Type With Shoulder
Finish Plain
System of Measurement Inch
Specifications Met Not Rated

These are from McMaster-Carr in quantities of 100 for about five or six dollars.
ra