Page 4 of 4
Posted: Thu Aug 11, 2016 1:26 pm
by rnordell
I bought this bit a few years ago and fell in love with it. A little expensive, but the replaceable inserts are a real nice feature.
http://www.amanatool.com/products/cnc-r ... ign-1.html
Posted: Fri Aug 12, 2016 5:05 am
by skimann20
I've been eyeing this one up. so you're happy with it? RPM and speed you run it at?
Posted: Fri Aug 12, 2016 8:02 am
by motoman
Nice tool, what speed you run it? and what depth per a turn?
Posted: Fri Aug 12, 2016 10:47 am
by rnordell
I'd have to go back and look, but off hand, I think around 15,000 RPM and 150 ipm? This puts the chip load at 0.005. I just looked and see that this agrees with the recommended feeds/speeds.
http://www.amanatool.com/media/custom/u ... 408200.pdf
Posted: Tue Aug 16, 2016 10:10 pm
by motoman
Posted: Sat Aug 27, 2016 2:42 pm
by Brazen
omg...you guys are STILL HERE?!?
Posted: Sat Aug 27, 2016 3:07 pm
by MontuckyMadman
Ahhhhh yep.
Posted: Sat Aug 27, 2016 5:49 pm
by twizzstyle
Brazen wrote:omg...you guys are STILL HERE?!?
I only come on from time to time to make sure nobody is pissing on each other and I have to moderate some sh1t. Making skis? Who's got time for that?
(full disclosure, I saw the above mentioned expensive bit, and immediately ordered it... followed by the next size up, cause my CNC spoilboard desperately needs leveling)
Posted: Sat Aug 27, 2016 10:30 pm
by motoman
Brazen wrote:omg...you guys are STILL HERE?!?
man, sure!)