Ski Builders Forum

falls wrote:I've used the 205 fast hardener before with layup time about 1 hour for the first few pairs.
Pot life isn't that long (9-12 minutes), but thin film time (60-70 minutes at 70F) I think is adequate - especially if you mix small amounts as you go and wet out your glass on a separate table.
http://www.westsystem.com/ss/hardener-selection-guide/
206 definitely gives you more time, but you need to press for 10-15 hours.

MontuckyMadman wrote:I agree with falls. The 206 is a 15 hour cure, silly.
If you wet the fabric separately you have time till gel.
If you leave it in the pot yeah your gonna have a bad time.
separate batches.
If west is all you can get fine, but there are better epoxies for skis and compression molding for the same cost, some cheaper.