Page 2 of 2
Posted: Wed Oct 13, 2010 3:43 am
by Brownj1
thats exactly what I was looking to hear. Thanks so much for the info.
Posted: Wed Oct 13, 2010 7:08 pm
by Brownj1
Turns out the outlet is actually 250V 50A which, from what i have read means that there are two hot lines and a ground running to it (so prob. 240V). I know that you can run a heating element off this set up (from what i have read) but was wondering if anyone knew how it would affect the wiring to PID and SSR. Thanks
Posted: Thu Oct 14, 2010 2:17 am
by krp8128
Brownj1 wrote:Turns out the outlet is actually 250V 50A which, from what i have read means that there are two hot lines and a ground running to it (so prob. 240V). I know that you can run a heating element off this set up (from what i have read) but was wondering if anyone knew how it would affect the wiring to PID and SSR. Thanks
Where are you located. USA or another country?
I'm about to run to work, and don;t want to mess up the explanation because I am rushing. PM and I'll give you a good how to later.
I've also put together a few controls for other people for parts+small fee, if you want to eliminate the hassle.