For discussions related to designing and making ski/snowboard-building equipment, such as presses, core profilers, edge benders, etc.
Moderators: Head Monkey , kelvin , bigKam , skidesmond , chrismp
zachjowi
Posts: 110 Joined: Sat Aug 26, 2006 10:41 am
Location: WI
Post
by zachjowi » Tue Aug 29, 2006 8:54 pm
this is what I plan to make out of 2"x2" steel tube and weld it. It will be 78" long.
Buuk
Posts: 150 Joined: Wed Apr 26, 2006 2:49 am
Location: The Netherlands
Post
by Buuk » Wed Aug 30, 2006 1:58 am
What will be the thickness of the tubes?
Buuk
zachjowi
Posts: 110 Joined: Sat Aug 26, 2006 10:41 am
Location: WI
Post
by zachjowi » Wed Aug 30, 2006 4:55 am
Buuk wrote: What will be the thickness of the tubes?
Buuk
14 gauge or about .83"
zachjowi
Posts: 110 Joined: Sat Aug 26, 2006 10:41 am
Location: WI
Post
by zachjowi » Sat Sep 02, 2006 9:14 am
I am going to make a ski press using 14 gauge 2"x2" hollow tubing. the length will be 78" long and I am going to try and use threaded rod to hole it together but I need help deciding a safe size to use so it won't break when I put a max of 80PSI distributed on the press.
Buuk
Posts: 150 Joined: Wed Apr 26, 2006 2:49 am
Location: The Netherlands
Post
by Buuk » Sat Sep 02, 2006 10:39 am
Check your email!
Buuk
zachjowi
Posts: 110 Joined: Sat Aug 26, 2006 10:41 am
Location: WI
Post
by zachjowi » Sat Sep 02, 2006 12:37 pm
I will be using these plans I made unless I change my mind again
littleKam
Site Admin
Posts: 269 Joined: Mon Dec 13, 2004 7:43 pm
Location: SoCal
Post
by littleKam » Sat Sep 02, 2006 1:15 pm
how do the short horizontal tubes connect to the top and bottom pieces?
- Kam S Leang (aka Little Kam)
zachjowi
Posts: 110 Joined: Sat Aug 26, 2006 10:41 am
Location: WI
Post
by zachjowi » Sat Sep 02, 2006 1:19 pm
littleKam wrote: how do the short horizontal tubes connect to the top and bottom pieces?
I haven't actually completed the drawing but I ma going to have rods go through the four 78" tubes. threre are 4 nuts on each vertical threaded rod
smalls.
Posts: 7 Joined: Sun Dec 19, 2010 5:31 pm
Post
by smalls. » Tue Oct 30, 2012 6:18 pm
looks like a good idea
sammer
Posts: 933 Joined: Wed Dec 19, 2007 10:37 pm
Location: Fernie B.C.
Contact:
Post
by sammer » Tue Oct 30, 2012 6:52 pm
You don't even have a legit signature, nothing to reveal who you are and what you do...
Best of luck to you. (uneva)
VeraKeisey
Posts: 1 Joined: Wed Oct 31, 2012 9:50 pm
Contact:
Post
by VeraKeisey » Wed Oct 31, 2012 10:23 pm
awesome. Thanks for sharing this.