Advice on Router

[TWC]

Is this a good enough router to get started making ski/boards?

hxxp://bit.ly/gNmqDE (link to Canadian Tire, replace xx with tt due to posting restrictions)

My concern is that it only has a 1/4'' collet.

[OAC]

Look as good as any, to me. Looks similar to the B&D, which we have here in Sweden. Haven't tried it, but looks good.
One thing to check (among others) is if it moves up and down easily and not get stuck on it's way. That can make me frustrated for a day (or two).
If you have read other threads here, you probably figured out that these machines are lethal.
So take your time and get used to it first. If you haven't used one before you will be surprised how fast they will go in all directions you don't want!
A core can be ruined in no time!

[OnDeck]

Perosnally, i owudl get soemwthing that will allow you to change out collets to larger sizes. Occasionally you have the need for it. I use the larger use on wood, and it makes increases your choice of bits.

[Richuk]

If its just for ski building, then 1/4" is fine - IMO. Take an interest in plunge depth. With a large machine like this and a router table (or similar), you'll be able to use a dovetail bit with a top bearing to remove the sidewall.

Amazon have been doing a few good deals recently ...

[skidesmond]

If you're going to use it for profiling cores I think you'll want a 1/2 inch collet and more HP for over all durability. That's a lot of force for 1/4inch and 1.75 hp. Not to say it wouldn't work, you just don't want to use too much force on a 1/4 shaft when profiling.

[Richuk]

doh - yep, sorry, I use a planner, so like I fool I think everyone else does

[TWC]

Thanks for the help everyone. That is exactly the types of thing I was worried about.