Press Frame / Legs only

[J]

have an extra set of press frame uprights that I really dont need or have room for, these would be a good starting point for a dual cavity press. Again these are the upright (i.e legs) ONLY.

You would need additional steel to complete for a fully functional press. The legs are made from 3/8 4" square steel tubing approx. 8' tall.

I am located in NYC area - and these would be for pick up only, they are heavy. To recreate these pieces the steel alone would be estmated at about 1200.00. (based on current 4x4 3/8 8' structural steel tubing prices).

I am asking 700.

I will see if I can dig up some pics if someone is interested.