Jsquared Year II

gozaimaas · Post by **gozaimaas** » Fri Feb 28, 2014 2:26 am

Looks great!

skidesmond · Post by **skidesmond** » Fri Feb 28, 2014 3:31 am

Nothing wrong with those boards! Nice job!

JSquare · Post by **JSquare** » Fri Feb 28, 2014 11:24 am

Thanks guys!

Chris, sorta a mix of stuff I posted up there...

Raw veneer boards i posted as just clear coated with spar urethane. I actually worked out a technique for brushing it on and it looks pretty damn good.

Finished board with artwork is via vince at miller studios, and my artist bled in some wood grain to the image to get that appearance.

Veneer topsheets with art are direct printed. I am planning to just clearcoat over them, but i have some coupon tests i'll run this week with that vs. some crown clear topsheet. I'll have to post up and let ya'll know what I decide to do!

JSquare · Post by **JSquare** » Wed Apr 16, 2014 8:34 pm

Too busy to post up my coupon results lately. Here's a sexy board though, same artwork just done on veneer and clear coated. Cherry sidewalls go so well with it, didn't mean for that to happen.

MadRussian · Post by **MadRussian** » Thu Apr 17, 2014 3:41 pm

nice-looking board

MontuckyMadman · Post by **MontuckyMadman** » Sat Apr 19, 2014 9:27 am

how is the veneer printed on?
Who provides this service?

Dtrain · Post by **Dtrain** » Sun Apr 20, 2014 7:17 am

He does it at home on an inkjet. I've been experimenting. Works we'll.

[/img]

MontuckyMadman · Post by **MontuckyMadman** » Sun Apr 20, 2014 8:52 pm

What kind of injek feed venneer?

Dtrain · Post by **Dtrain** » Sun Apr 20, 2014 9:07 pm

A couple of guys on here including myself have an epson 1400.

MontuckyMadman · Post by **MontuckyMadman** » Sun Apr 20, 2014 9:57 pm

That will do sublimation inks as well right?

Dtrain · Post by **Dtrain** » Mon Apr 21, 2014 6:23 am

Yup. External or internal ciss ink systems.

hegan · Post by **hegan** » Mon Apr 21, 2014 7:46 am

Really printing right on to the veneer? This printer is 10 feet from me right now, I need to try some veneer on it.

Dtrain · Post by **Dtrain** » Mon Apr 21, 2014 7:51 am

Oh hell ya. With that I'd try printing right on the underside of clear base material as we'll.

chrismp · Post by **chrismp** » Mon Apr 21, 2014 10:27 am

Dtrain wrote:Oh hell ya. With that I'd try printing right on the underside of clear base material as we'll.

Tried it...doesn't really work. The ink runs on the rough surface and doesn't stick to it.

knightsofnii · Post by **knightsofnii** » Wed Apr 23, 2014 4:24 am

how does the printer apply the ink to the surface? does it "blot" dots? or spray drops? either way, try to reduce the amount that comes out per dot or blob or drop or whatever.

I know others that talked about direct printing mentioned they had to tweak settings alot.

Ski Builders Forum

Ski Builders Forum

Jsquared Year II