Page 1 of 1

First pair finally blew up.

Posted: Sat Feb 08, 2014 11:21 am
by gketcham
After 6 days of hard skiing, I found my failing point. I used to sections of sidewall on both sides, so it had white going 1/3 of the ski and green going 2/3.
I went off a cliff and caught a rock and rolled, blowing just the sidewall off the ski, it was waving in the wind behind me as I skied the rest of the mountain. I recommend not doing split sidewalls, unless you have a better joint to connect the two. The skis are still skiing normally though, just screws in the inside wall. Super ghetto however.

Posted: Wed May 21, 2014 9:18 am
by Danielbroski
Same thing happened to me but I had one continuous sidewall I just sucked putting it on. The screw I put in worked fine but like you said was super sketch.

Posted: Wed May 21, 2014 2:16 pm
by amidnightproject
Sounds like it's more of a bonding issue. I've done a few pair with varying length sidewall segments attached (pairs for myself when material was low or for prototyping). Never had an issue. Did you abrade and flame treat everything?