i was wondering what the best way to install the pneumatic rams that on3p uses to increase psi on the tip and tail section. rght now i have shimmed my cat track with bamboo but i dont think that it is thebest way to do it. i am super interested in the rams

any idea where to get that

Best thread ever!!!!!!!

FIXED: i talked to the guys at entropy resins which was great. turns out i was not cooking them as long as i needed to be. i doubled my cure time and now i have everything good. turns out i was doing everything else right so good call on the epoxy issue

Thanks guys

just pulled my last ski out press and i got camber like i wanted by switching blanket. thanks for the tip

liked it

i have the exact same PID controller and i pair it with

http://www.auberins.com/index.php?main_ ... 17f5659524

and it works very well and is super easy to wire up and use.

great post, my self and many friends picked up bindings.

i think i may not have cooked my skis long enough, i just did a test with base,fg,tip spacer, fg topsheet and i watched the temp climb new thermocouple and watched the temp climb and it was a lot slower than i was expecting so i will be adjusting where i put the thermocouple, also i talked with the ...

do you think that storing my materials in the garage is contributing to all my problems, because the temperature is fluctuating where do you guys keep your stuff

i talked to the guy at entropy and he said that i would be fine to cut the flash after it cools. i usually wait about an hour or 2 to let is cool then cut the flash

i will get a scale tomorrow

also when i glued up some sidewalls today i did the water droplet test on them and the water spread out and seeped into the part i flamed and beeded on the part i did not. so i think i am flaming right. do you think it could be the pumps i am using not giving me an accurate measurement of epoxy to h...

joe lohr is my roomate how do u know him??????? and to answer your question montukey, i am using entropy cpm, i am using calibrated pumps to measure my epoxy, and i am being really carefull. should i get a scale and do it by weight to be more accurate. i am am flame treating the side wall and tip sp...

i am having a really hard time getting my tip spacer to bond well to the fiber glass. i am sanding then flame treating it

Any ideas

OOOOOOOO im hot usually bout 185, that what my girlfriend tells me. she calls me hot stuff. all joking aside i have been heating from the top but i will call mei tomorrow and see if i can put the blanket in my casset and if they think its all good i will switch to the bottom. i built a mold that has...