Search found 33 matches
- Fri Jan 14, 2011 1:15 am
- Forum: Ski/Snowboard Design and Layup
- Topic: Split Board Inside edge question
- Replies: 12
- Views: 7996
I messed with routing out for a new inner sidewall but did not put in any edges. I used a small rigid trimmer with a 1/8 straight bit and the adjustable bearing assembly that comes with the router. Set the bearing away from the bit the same distance as the thickness of the base / topsheet material. ...
- Sun Dec 12, 2010 7:24 pm
- Forum: Ski/Snowboard Design and Layup
- Topic: First board pressed is going flat?
- Replies: 3
- Views: 1979
Well the board was fun for the half run that I had on it. Hit a rock and had a total failure. The base didn't even hardly scratch but the one half of the spiltboard snapped in half. Seamed to shear right down one of the veneer layers. The cloth I'm using is white 7.5 oz with a 90 degree weave. Doesn...
- Sat Dec 11, 2010 3:04 pm
- Forum: Ski/Snowboard Design and Layup
- Topic: First board pressed is going flat?
- Replies: 3
- Views: 1979
First board pressed is going flat?
Hey All, First off just just like to thank you all for sharing your knowledge. Couldn't have got this far without it. Anyhow just pressed my first board (splitboard) and it seems to be losing it's shape a little more each day. Way beyond what I'd figure for an average ratio of springback. The layup ...