Hi there, I've made a few skis now with reasonable success but one i made the other day went horribly wrong when a lot of epoxy managed to get under my edges at the tip and tail and somehow stopping the edges take the shape of the camber mold and then going of with the heat mats so now i have a ski ...

i use 9mm fibre cement board which is glued to 18mm mdd sheet thats attached to the steel frame. i think it may be down to what chrismp said with the top sheet being able to wrinkle when the silicon blanket gets warm and deforms ill try with a aluminium sheet o top of it to try and maintain two flat...

The sublimation press i have consists of; 5 air rams 300m apart pressing a steel bed 9mm fibre cement sheet silicon heat blanket 5mm aluminium sheet graphics and top sheet 5mm silicon blanket 18mm mdf steel frame again The air rams are ran at 90psi and apply quite a lot of pressure i run the heat bl...

https://i.imgsafe.org/f8bf3df082.jpg https://i.imgsafe.org/f8ce280ab2.jpg https://i.imgsafe.org/f8d1668956.jpg https://i.imgsafe.org/f8d1c74eab.jpg My sublimation press keeps doing this in the transfer process, i can't figure out why as i have had perfect results with the exact same settings. can hi...

Hi amidnightproject how much pressure are you putting through that thing and what time and heat are you using because I'm about ready pull my hair out trying to get the combination right. Also what type of blanket are you using under the top sheet, it looks quite thick. I've got a 5mm silicone rubbe...

Im sure this question has already been asked, but what methods are being used to stop the core being uplifted and destroyed at the tips and tails whilst running through the planer? I can get a perfect outcome when the sidewall is not attached but as soon as i try profile the core with sidewalls atta...

Hi there, Ive decided i want to give it a go doing dye sublimation for my top sheet graphics but am finding it hard to find any info on the net. Could anyone out there help me out and let me know any do's and dont's with the process. Also what type of printer do i need and inks and what not? Thanks ...

Hi,

Im looking at doing some screen printing on the underside of my top sheet and was wondering if there were any specific inks i should use that are better or do not affect the bonding with the resins and top sheet.

I hope you guys can help.

Thanks

Hi Does anyone know the recommended temperature to use in the printing press when dye sublimating? Im using UHMW plasting designed for dye sublimating and is 0.76mm thick.
The last attempt, the plastic came out all wavy after going under the heat of the printing press.
Thanks a lot Matt