Does anyone has a Crown contact, Iv sent 4 email from 2 addresses, and never get an answer by using their webpage contact form or the email provided there.

Thx!

I was able to get 1L from Berlac few months ago, write to, Levente.Buzogany@berlac.ch, www.berlac.com

If you dont find any suppliers, send me an email to junksupply.com , Ill give you an offer.
Miki

You could also consider a full width VDS or a full width cork rubber material....or it might be a press/mold/layup issue of some sort that can be fixed without extra layers...

Just in case you need verified press component suppliers, I put all my suppliers in a list here,
https://www.junksupply.com/making-a-heated-press/

Cheers
Miki

i do have some on stock on junksupply. bamboo is very heavy, plus dimensions are long, so shipping to another continent would be too much.

guys for screen print or for back print also try basler or berlac from switzerland!

Hi guys, I do reply the emails and requests within same day, in case you dont get reply, it might happen that you put in the wrong email address on contact form...in general always better to send email to mail@junksupply.com or even whatsapp +46 769293498
Cheers,
Miki

Hi there, we also stock some vacuum supplies on www.junksupply.com

Cheers!
Miki

I collected all my suppliers here:
http://www.junksupply.com/making-a-heated-press/

Hi ppl! I would sell mu sublimation setup. Location: Sweden - Epson t3200 printer, perfect condition, 2 years old, refillable ink cartridges, J-teck ink 4L etc. - Press: whole setup: table, top with silicone membrane, insulators, heating blanker, electronics etc. I spent over 4k euro on this, I woul...

Hello builders, Beside offering ski and board materials and shipping all over the world, I can now report that the graphics printing is finally working well for both kite and wake boards and ski and snowboards on PBT, Ptex and PA materials. It has taken a while to get all to play together, but final...

hit me up on junksupply with the list of material and I can provide you a quote from Sweden as well. I am not sure if it is cheaper or more expensive, but than you have a comparison. I get some buyers from Australia, as I understand, there is no option in Australia. I think its mainly as most of the...

Hi, I found this one in a local store, its some kind of mineral board (promatect L), used to fireproof buildings. It works well for vacuum press, I dont think it will work in pneumatic press, it will crack. http://www.beijerbygg.se/store/privat/byggmaterial/byggskivor/cementbaserade-skivor/skiva-pro...

I use a vacuum press for sublimation. I run thru 3 presses until I designed a one that works well. Setup, --silicone membrane/blanke --2 layers of breather 150gms fabric --sub paper --sub topsheet --2mm aluminium sheet --silicone heating blanket --isolation --ABS sheet for vacuum seal --MDF table I ...