FSC? ;-)

I have some tuning specs for one somewhere. Let me dig around.

I too would be interested if you sell in smaller batches.

looks like you don't email notifications when some one posts on your thread?

sorry for the delay. It has been sold.

Dropping to 2999.

Mammuth: i love this! quality.

My first base grinder...

Looks super clean and for a great price.

I have about 30'
New
Yellow

I got tired of my compressor running every 3min because of holes in my old hose... now my compressor inflates my hoses and doesn't run the remainder of the press time. Sooooo nice.

Let me know what you need.
cheers,
~Brad

Keep going all the way out? Maybe its just the design of my ski, but the bit would take a chunk from the rise in the tip/tail if I did that. You have to keep the part of the ski that is even with the bit flat. so as your tip and tail come closer to bit you actually have to pick up ski in the tip or...

I do

Clearing sidewalls off with 80 Brown or Blue

Base: 80 Blue, 100 Blue, 120 green (make sure to detune 80 and 100 before first use and I run an old ski over 120 a few passes before first use)

side wall 120 Green

Stone

Hand tune

One thing that I found was that my sheet cam was zeroing at the top of the material and not the top of the table. So i had to zero at top of material and run my swivel height backwards (i think). I was giving the following info, but have to confirmed: If you go to Options->machine->post processor yo...

I'm with Montucky, these will grind out fine.

I too just had an issue with my SG not holding (pre-press) but this was in the tips. My thought: Sometimes when I put to much glue initially, then i don't get good bonding. It doesn't set well. perhaps this was your issue, you used too much SG?

LumberJacked wrote:The man, the myth, the legend! I remember where I've seen it now! haha thanks.

I know right! His website is directly responsible for me spending thousands of dollars on ski building. i owe him a beer at some point.

$3250 and I'll throw in (4) Sip of Sunshine...

Looks like some nice new "tires" you got there. I'm sure that will help a ton with the finish of the base.

Got any before and after pictures? I'd be interested in seeing it.