Top rated |
|

Kublai3120 viewsThis is my ski press. Made from 4 large (9' long) steel I-beams and a lot of love. It has a temperature controller which heats the base mold.     (16 votes)
|
|

2420 viewsI like to ski, and I like skis.     (9 votes)
|
|

the think pinks2634 viewsthe think pinks--1st homebuilt pair     (15 votes)
|
|

Hard Maple3884 viewsAnother pair of Hard Maple skis that where sold with a 3 pin binding.      (12 votes)
|
|

Klown Whacker2240 viewsThe Klown Whacker is my first homemade ski.     (21 votes)
|
|

One down One to go2915 viewsAlmost done...     (9 votes)
|
|

The tool4566 views A picture showing all of the parts that go with this tool. The center boards are 100, 135, 150 cm. (shown with the 100cm center board installed). Two tip tools are at the end of the center boards for regular skis. The board leaning up on the back of the table is going to be covered with glass and cut into sections 10cm-40cm to get more adjustablility in the tool for more ski/snowboard lengths.     (10 votes)
|
|
|
|
|
|
348 files on 29 page(s) |
1 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|