| Last additions - Hafte |
Sealing the top3517 viewsThe shiny spots are packing tape to seal up the screw holes and the crack between the tip tool and the camber tool surfaces.Sep 28, 2009
|
|
End view3931 viewsThe end of the tool showing the way the tip tool finger joins to the camber/bottom tool.Sep 28, 2009
|
|
The whole tool4504 viewsThe tool with the reverse camber tips installed. That's a mono ski base and edges sitting on top. I coat the surface of the tool with glass for a tougher surface and a better seal for the vacuum.Sep 28, 2009
|
|
The tool4570 views A picture showing all of the parts that go with this tool. The center boards are 100, 135, 150 cm. (shown with the 100cm center board installed). Two tip tools are at the end of the center boards for regular skis. The board leaning up on the back of the table is going to be covered with glass and cut into sections 10cm-40cm to get more adjustablility in the tool for more ski/snowboard lengths.Sep 28, 2009
|
|
more views3864 viewsThat's my Mountain Popsicle Stix on the tool. Its the first reverse camber ski that I designed. The tips have the reverse camber. There is 109 cm of regular camber in the center and a touch of sidecut also. I made the ski for the area I ski at. There are a bunch of cat tracks and traverses that you need to do to get to the goods on this mountain and I wanted the stability in those situations.Sep 28, 2009
|
|
3355 viewsSep 28, 2009
|
|
1649 viewsOct 07, 2008
|
|
1478 viewsOct 07, 2008
|
|
1688 viewsOct 07, 2008
|
|
1455 viewsOct 07, 2008
|
|
1320 viewsOct 07, 2008
|
|
1444 viewsOct 07, 2008
|
|
|
|
